To put new belts on a John Deere 568 Round Baler, you can follow these steps:
- Preparation:
- Park the baler on a level surface and engage the parking brake.
- Turn off the engine and remove the ignition key for safety.
- Lower the pickup and set the bale density control to the minimum setting.
- Gather the necessary tools and the new belts for installation.
- Removal of Old Belts:
- Remove any belt guards or covers that provide access to the belts.
- Take note of the belt routing and take pictures or make diagrams for reference during installation.
- Release the tension on the old belts by loosening the tensioning mechanism. This may involve adjusting tensioning bolts or releasing tension from spring-loaded mechanisms.
- Carefully remove the old belts, taking note of their orientation and any specific attachments or connections.
- Installation of New Belts:
- Start by threading the new belts onto the appropriate pulleys and rollers, following the belt routing diagram or reference pictures.
- Ensure that the belts are properly aligned and seated in the grooves of the pulleys.
- Adjust the tensioning mechanism to apply proper tension to the belts. Consult the baler’s manual or manufacturer’s guidelines for the recommended tensioning procedure and specifications.
- Gradually tighten the tensioning mechanism to achieve the desired tension on the belts. Avoid over-tightening, as it may cause premature wear or damage to the belts.
- Check the alignment and tracking of the belts as you tighten the tension, making any necessary adjustments to ensure they run smoothly and centrally on the pulleys.
- Reinstallation of Belt Guards and Covers:
- Once the new belts are properly installed and tensioned, reattach the belt guards or covers to protect the belts and ensure safe operation.
- Double-check that all guards are securely fastened and properly aligned.
- Testing and Adjustments:
- Start the baler and run it without a bale to observe the new belts in operation.
- Verify that the belts are tracking properly and running smoothly on the pulleys.
- Make any necessary adjustments to the tension or alignment as needed to achieve optimal performance.
It’s important to note that these steps provide a general guideline for installing new belts on a John Deere 568 Round Baler. However, specific instructions may vary based on the model and configuration of your baler. Therefore, it is recommended to consult the baler’s manual or seek guidance from a John Deere dealer for detailed instructions tailored to your specific machine.
When working on your baler, always prioritize safety. Follow proper safety procedures, wear appropriate personal protective equipment, and be cautious when working around moving parts or tensioning mechanisms.
If you are not confident in your ability to install the new belts, it is advisable to seek assistance from a qualified technician or a John Deere dealer who can ensure the proper installation and functioning of the belts on your baler.
